Announcement

Collapse
No announcement yet.

Check engine light on and emission soon

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • #16
    If you have a scanner you can possibly pass emmisions,
    1st you have to clear the code. If the code clears and doesnt come right back on your all set to go to the next step.
    Keep your scanner plugged in while the car is running and go to "drive cycle monitors"
    You should have 5 monitors inconclusive...Drive the car until you have only 2 monitors left..any car older than 2000 is allowed 2 monitors on..you just have to catch it before your check engine light come back on.

    Comment


    • #17
      Originally posted by monkeyblack View Post
      Na I dont have a civic for to be emissioned


      how much could an o2 sensor possibly be?
      2004 Accord DX
      2005 Ruckus

      Comment


      • #18
        me to i had a cat code and cilinder 2 misfire i changed spark pluges drove and passed recentally

        Comment


        • #19
          reseting doesn't always work because it shows up pending i know this just went through it
          HWR
          13203 RIP Nhswaps
          School of Hard Knocks

          Comment


          • #20
            Originally posted by jealous1shateric View Post
            only domestic cars have the p1000 issue, im my case i have a 98 civic with a gsr ecu I went to emission with 2 o2 sensors and no cat and pass with flying colors
            im not sure what you mean? i passed my si with no cat and primary o2 no after cat o2. i failed first time around due to system not ready becuz i figured if i cleared the codes 2 m b4 i went id be ok, dident happen and i had to address problems and go back

            also i had an obd1 motor in an obd2b car with single cam harness

            Comment


            • #21
              Originally posted by mark11017 View Post
              im not sure what you mean? i passed my si with no cat and primary o2 no after cat o2. i failed first time around due to system not ready becuz i figured if i cleared the codes 2 m b4 i went id be ok, dident happen and i had to address problems and go back

              also i had an obd1 motor in an obd2b car with single cam harness
              i meant that if ur sensors are good than u wont need a cat, well in mass u dont
              Follow me @bolacan413
              Follow the build @k_insight

              Comment

              Working...
              X