manual to power window conversion ek

[Jovanni91Da]

I have the driver side working and ready to go. The passenger side is wired up but still won't go up or down

[Jovanni91Da]

Bump

[jdmdikk]

you probably wired it up wrong or you probably plugged the motor to the wrong plug on the harness..there are 2 plugs that are the same..so take a look at that

[$$swizz$$]

U ghetto wrigged it or official power door harness cause if its power door harness it should be plug and play

[SeanJDMJohn]

Up Ik it's not easy as it sounds take ur time with it

[Jovanni91Da]

Up Ik it's not easy as it sounds take ur time with it

Driver side was easy passenger just a little headache wires are connected up might have one wrong Idk

[jdmdikk]

Driver side was easy passenger just a little headache wires are connected up might have one wrong Idk

Shoot me a pm if u need help bro. It's easy to wire them up. All u have to do is run 3 wires from the passenger door towards the drivers kick panel. 2 wires are going to connect to the 2 wires from the drivers side(same colors).the 3rd wire will be the power wire. U connect that wire to the power wire from the drivers side and put a 15 or 20A (don't remember which one) in line and connect it to your ignition wire. The 4th wire from your drivers side will be ground. They will work like factory and u can control both windows from the drivers side

Check this thread out. It will tell you what colors go to what

http://www.hondahookup.com/forums/showthread.php?152818-DIY-Power-windows-in-a-96-00-civic-DX

[Jovanni91Da]

Shoot me a pm if u need help bro. It's easy to wire them up. All u have to do is run 3 wires from the passenger door towards the drivers kick panel. 2 wires are going to connect to the 2 wires from the drivers side(same colors).the 3rd wire will be the power wire. U connect that wire to the power wire from the drivers side and put a 15 or 20A (don't remember which one) in line and connect it to your ignition wire. The 4th wire from your drivers side will be ground. They will work like factory and u can control both windows from the drivers side

Check this thread out. It will tell you what colors go to what
http://www.hondahookup.com/forums/sh...96-00-civic-DX

Did all of this still nothing lol

[Jovanni91Da]

Shoot me a pm if u need help bro. It's easy to wire them up. All u have to do is run 3 wires from the passenger door towards the drivers kick panel. 2 wires are going to connect to the 2 wires from the drivers side(same colors).the 3rd wire will be the power wire. U connect that wire to the power wire from the drivers side and put a 15 or 20A (don't remember which one) in line and connect it to your ignition wire. The 4th wire from your drivers side will be ground. They will work like factory and u can control both windows from the drivers side

Check this thread out. It will tell you what colors go to what
http://www.hondahookup.com/forums/sh...96-00-civic-DX

Did all of this still nothing lol

[jdmdikk]

did u try plugging the passenger motor into the other plug thats on the passenger harness? i had made the same mistake and all i had to do was unplug it and plug it into the other plug and it worked perfectly fine.there are 2 clips that are exactly the same.u might have it plugged into the wrong one bro