Need help on my b20 swap in a eg hatch

[S13whatt]

I put a 97 b20b in my hatch. Changed the long intake to a ls short intake and am using the b20 throttle body. Put a ls obd1 dizzy and everything plugged right in. Firing order is good. Check engine light is on but I haven't connected my o2 sensor yet cause I have to extend the wire. It runs rough and when I rev the motor it stalls and turns off. I'm stuck

[djkiley]

Bump

[jdmkid618]

Youll def get the help u need

[S13whatt]

Thanks. I hope so

[S13whatt]

I put a p75 ecu and p75 intake btw

[CTgoldhatch]

cheack the timein belt and compression

[JDMjoe]

make sure the timing is right

[jealous1shateric]

Jdm? U need the crank. Sensor

[S13whatt]

Yea it's a jdm b20 with the fuel rail on the other side and caution hot sign ontop

[CTgoldhatch]

if you are runnin a obd1 dizzy shouldent matter that is all built in the dizzy. make sure the timeing marks are right and do a compression test.

[elpepe]

when you say rough what exactly do you mean?? misfire, holds back power?? can be alot of things more info/details will narrow down suggestions

[S13whatt]

if you are runnin a obd1 dizzy shouldent matter that is all built in the dizzy. make sure the timeing marks are right and do a compression test.

I'll do that tomorrow..it's weird though cause if I start to rev is slowly it sounds good but then when I give it more gas it just stalls

[S13whatt]

when you say rough what exactly do you mean?? misfire, holds back power?? can be alot of things more info/details will narrow down suggestions

At idle he rpms rev up and down an yea it hold back power..I tried to go up a hill and it just turned off. I was able to get it up the hill and back into the garage by having my boy open the throttle body manually while I let go of the clutch

[elpepe]

do you have it open headers or does it have a catalytic converter??

[S13whatt]

do you have it open headers or does it have a catalytic converter??

Has a stock ls exhaust and I replaced the cat with a test pipe